Full Text
440-2644 (8/25/COM) Residential Plan Submittal Intake Checklist Department of Consumer and Business Services Building Codes Division • 1535 Edgewater NW, Salem, OR Mailing address: P.O. Box 14470, Salem, OR 97309 [PHONE REDACTED] • Web: www.oregon.gov/bcd FOR DEPARTMENT USE ONLY Permit No.: Office: PROJECT TYPE & APPLICABLE CODE EDITION New residence Alteration/addition to existing residence New, detached accessory structure Alteration/addition to existing detached accessory structure Deck Repair ORSC Edition MINIMAL SUBMITTAL REQUIREMENTS CHECKLIST FOR PLAN REVIEW Provided N/A 1. Local planning/zoning, water district, erosion control, DEQ/septic/sewer approval. 3. Site/plot plan Show the size and location of new construction and existing structures on the site and distances from lot lines. Reference ORSC Section R106.2. 4. One complete set of construction documents. Construction documents must be of sufficient clarity to indicate location; site specific design criteria per Table R301.2(1); nature and extent of the work proposed; and show in detail conformity to the provisions of the code, relevant laws, ordinances, rules and regulations. Paper copies must be sufficient size and quality for scanning. Reference ORSC Section R106.1.1. 5. Foundation plan. Provide plan dimensions, footing sizes, posts, anchor bolts, hold-downs, associated details, including reinforcement requirements and foundation vent locations. Reference ORSC Chapter 4. 6. Floor plans. Provide dimensions, room identification, door size, window size, location of smoke and carbon monoxide alarms, water heater, furnace, ventilation fans, plumbing fixtures, and balconies and decks that are 30 inches above grade. (Remodels/additions: Plans must be included for before and after the work is finished.) Reference ORSC Chapter 5. 7. Cross sections and details. Show all framing members such as floor beams, headers, joists, sub-floor, wall construction, and roof construction. More than one cross section may be required to clearly portray construction. Show all wall and roof sheathing, roofing, roof slope, ceiling height, siding material, footings and foundation, stairs, fireplace construction, thermal insulation, etc. Reference ORSC Section R106.1.1. 8. Elevation views. Provide dimensions, including but not limited to, floor and roof eave and ridge elevations, opening locations, and finish grade profile. Reference ORSC Section R106.1.1. 9. Wall bracing. Provide engineered or prescriptive lateral calculations and plans showing braced wall lines, bracing method, location and length of braced wall panels, and associated connections to roof, floor, and foundation. Lateral design details and connections shall be incorporated into the plans. Reference ORSC Sections R106.1.3, R602.10, R301.1.3. Refer to for prescriptive wall bracing calculators. 10. Floor/roof framing plans. Provide a plan for each roof and floor framing assembly that shows all structural framing members and supports, their sizes, spacing, species, grade, bearing locations, method of attachment (e.g. hardware), roof pitch, and attic ventilation requirements. Reference ORSC Chapter 5 and Chapter 8. 11. Design calculations. Provide for all structural load carrying members that are not based on prescriptive span tables in the code. Reference ORSC Section R301.1.3. 12. Floor and/or roof trusses. Provide the design layout plan with truss details and calculations that have been stamped by an Oregon licensed engineer. Reference ORSC Sections R502.11 and R802.10. 13. Energy code compliance. Show compliance with Chapter 11 Energy Efficiency, identifying the additional Envelope Enhancement Measure and Conservation Measure chosen from Table N1101.1(2) (when applicable). Where Envelope Enhancement Measure No. 6 is chosen, provide supporting calculations (refer to stand/Pages/residential-structures.aspx for thermal performance calculator). Reference ORSC Chapter 11. Note: This checklist must be completed in full before the plan review process will begin. Applicant: Date: Building Codes Division employee (print name): Date: SIGN SIGN SIGN SIGN