Full Text
Annual Water Quality Report 2016 Water Testing Period PWS ID #2290023 ---PAGE BREAK--- Meeting the Challenge We are once again proud to present to you our annual water quality report. This edition covers all testing completed from January 1 through December 31, 2016. Over the years, we have dedicated ourselves to producing drinking water that meets all state and federal drinking water standards. We continually strive to adopt new and better methods for delivering the best quality drinking water to you. As new challenges to drinking water safety emerge, we remain vigilant and meet the challenges of source water protection, water conservation, and community education while continuing to serve the needs of all our water users. Please share with us your thoughts about the information in this report. After all, well-informed customers are our best allies. Lead Information Statement HEALTH EFFECTS AND WAYS TO REDUCE EXPOSURE The City of Moscow is in full compliance with lead testing rules, and has never had a sample set fail for high lead content. In 2016, City of Moscow Water Staff took several samples from residences constructed during the period when lead was being used and all samples were below the federal level. In addition, we have no reason to believe that we have elevated levels of lead in the City of Moscow water system based on routine monitoring data. However, if present, elevated levels of lead can cause serious health problems, especially for pregnant women and young children. Lead in drinking water is primarily from materials and components associated with service lines and home plumbing. The City of Moscow is responsible for providing high-quality drinking water but cannot control the variety of materials used in plumbing components. When your water has been sitting for several hours, you can minimize the potential for lead exposure by flushing your tap for 30 seconds to two minutes before using water for drinking or cooking. If you are concerned about lead in your water, you may wish to have your water tested. Information on lead in drinking water, testing methods, and steps you can take to minimize exposure is available from the Safe Drinking Water Hotline ([PHONE REDACTED]) or at www.epa.gov/safewater/lead. Additional Health Information Some people may be more vulnerable to contaminants in drinking water than the general population. Immuno-compromised persons such as persons with cancer undergoing chemotherapy, persons who have undergone organ transplants, people with HIV/ AIDS or other immune system disorders, some elderly, and infants can be particularly at risk from infections. These people should seek advice about drinking water from their health care providers. EPA/ CDC guidelines on appropriate means to lessen the risk of infection by and other microbial contaminants are available from the Safe Drinking Water Hotline at [PHONE REDACTED]. Where Does My Water Come From? Moscow has five wells which draw water from two underground aquifers; the shallow aquifer known as the Wanapum, and a deeper aquifer called the Grand Ronde. Wells No. 2 and No. 3 draw water from the Wanapum System, and Wells No. 6, No. 8, and No. 9 draw water from the Grande Ronde System. To protect our source water, the City of Moscow implements best management practices aimed at protecting the wellheads and surface seals within the zone immediate to the wells. Source Water Assessment A Source Water Assessment for the City of Moscow was completed in 2001. The assessment determined that Wells No. 2 and No. 3 have overall higher susceptibility risk ratings, compared to Wells No. 6, No. 8 and No. 9. The City of Moscow has never had a sample exceed the Maximum Contaminant Level (MCL) for possible contaminates. A copy of the Source Water Assessment can be obtained from the State of Idaho Department of Environmental Quality (DEQ). For more information regarding the assessment, contact Kyle Steele at [PHONE REDACTED]. Questions? For more information about this report, or for any questions relating to your drinking water, please call one of the following people: Kyle Steele, Environmental Services Supervisor [PHONE REDACTED] Mike Dimmick, Water Production Supervisor [PHONE REDACTED] Mike Parker, Water Utility Manager [PHONE REDACTED] Tyler Palmer, Deputy Director – Operations [PHONE REDACTED] Les MacDonald, Public Works Director [PHONE REDACTED] FIND THIS WATER QUALITY REPORT— AND MORE—ONLINE Go to www.ci.moscow.id.us/water and check out the links on the left side of the page. Here you can view current and past Water Quality Reports, Backflow, Residential Fat, Oil, and Grease (FOG) Reduction Program, Wastewater Treatment Plant FAQs, and Water Conservation Program information. These are just a few of the pages available, with more to come. Take a look and let us know if there is anything else you would like to know about. ---PAGE BREAK--- Cross Connection Control Program BACKFLOW PROTECTION As you can see in the water quality testing included in this report, the Moscow Water Staff diligently monitor the water that is produced and distributed to the community to ensure that it is safe for all Moscow residents. However, this is not the end of the story for the safety of your water. The fixtures, faucets, equipment, and systems in the homes and businesses connected to the distribution pipes are a direct route for potentially harmful stuff which can contaminate your water supply. The City’s Cross Connection Control Program (CCCP) is in place to ensure that undesirable and hazardous materials are not introduced into your water system, through a process called backflow, and distributed to the rest of the community. This program is required by the “Idaho Rules for Public Drinking Water Systems” (IDAPA 58.01.08) and Moscow City Code Title 7, Chapter 9. A cross connection is any actual or potential connection to the public water system through which it is possible to introduce anything other than the intended potable water. This includes used water (water that has left the City’s distribution system), biological or chemical contaminants, and water from auxiliary (private) wells. Backflow is the flow of any liquids (including used water), gases, or substances in the wrong direction back into the public water supply. This can happen in two ways: by a drop in pressure in the distribution system that creates backsiphonage, which pulls water backwards; or by an increase in pressure on an external system that creates backpressure, which pushes water backwards. When it is determined that a cross connection which may endanger your public water supply is present, an approved backflow assembly must be installed. A backflow assembly is a device which is designed to be tested and repaired without having to be removed. All backflow assemblies must be inspected and tested annually by a State of Idaho licensed Backflow Assembly Tester (BAT). Note that an assembly that fails testing must be repaired, replaced, or isolated within ten (10) business days, or water service must be shut off. Over the past five years an average of 6.3% of backflow assemblies in Moscow failed the initial test. The protection of Moscow’s water supply is of critical importance to both the City of Moscow and its citizens. If you have any questions about the CCCP or would like to schedule a cross connection assessment, please contact Ty Thompson at [EMAIL REDACTED] or by calling [PHONE REDACTED]. Substances That Could Be In Water To ensure that tap water is safe to drink, the U.S. EPA prescribes regulations limiting the amount of certain contaminants in water provided by public water systems. U.S. Food and Drug Administration regulations establish limits for contaminants in bottled water, which must provide the same protection for public health. Drinking water, including bottled water, may reasonably be expected to contain at least small amounts of some contaminants. The presence of these contaminants does not necessarily indicate that the water poses a health risk. The sources of drinking water (both tap water and bottled water) include rivers, lakes, streams, ponds, reservoirs, springs, and wells. As water travels over the surface of the land or through the ground, it dissolves naturally occurring minerals, in some cases radioactive material, and substances resulting from the presence of animals or from human activity. Substances that may be present in source water include: MICROBIAL CONTAMINANTS, such as viruses and bacteria, which may come from sewage treatment plants, septic systems, agricultural livestock operations, or wildlife. INORGANIC CONTAMINANTS, such as salts and metals, which can be naturally occurring or may result from urban stormwater runoff, industrial or domestic wastewater discharges, oil and gas production, mining, or farming. PESTICIDES AND HERBICIDES, which may come from a variety of sources such as agriculture, urban stormwater runoff, and residential uses. ORGANIC CHEMICAL CONTAMINANTS, including and volatile organic chemicals, which are by-products of industrial processes and petroleum production, and may also come from gas stations, urban stormwater runoff, and septic systems. RADIOACTIVE CONTAMINANTS, which can be naturally occurring or may be the result of oil and gas production and mining activities. For more information about contaminants and potential health effects, call the U.S. EPA’s Safe Drinking Water Hotline at [PHONE REDACTED]. ---PAGE BREAK--- Sampling Results During the past year, we have taken hundreds of water samples in order to identify the presence of any radioactive, biological, inorganic, volatile organic, or organic contaminants. The table below shows only those contaminants that were detected in the water. Although all of the substances listed here are under the Maximum Contaminant Level (MCL), we feel it is important that you know exactly what was detected and how much of the substance was present in the water. The state allows us to monitor for certain substances less than once per year because the concentrations of these substances do not change frequently. In these cases, the most recent sample data are included, along with the year in which the sample was taken. DEFINITIONS The MCL for beta particles is 4 mrem/year. The U.S. EPA considers 50 pCi/L to be the level of concern for beta particles. AL Action Level – The concentration of a contaminant which, if exceeded, triggers treatment or other requirements which a water system must follow. MCL Maximum Contaminant Level – The highest level of a contaminant that is allowed in drinking water. MCLs are set as close to the as feasible using the best available treatment technology. MCLG Maximum Contaminant Level Goal – The level of a contaminant in drinking water below which there is no known or expected risk to health. allow for a margin of safety. MRDL Maximum Residual Disinfectant Level – The highest level of a disinfectant allowed in drinking water. There is convincing evidence that addition of a disinfectant is necessary for control of microbial contaminants. Maximum Residual Disinfectant Level Goal – The level of a drinking water disinfectant below which there is no known or expected risk to health. do not reflect the benefits of the use of disinfectants to control microbial contaminants. NA Not Applicable pCi/L Picocuries per Liter – A measure of radioactivity. ppb Parts per Billion – One part substance per billion parts water (or micrograms per liter). ppm Parts per Million – One part substance per million parts water (or milligrams per liter). REGULATED SUBSTANCES Substance Typical Source Unit of Measure Year Sampled MCL [MRDL] MCLG Amount Detected Violations MRDL Contaminant Typical Source Unit of Measure Sample Date MCL [MRDL] MCLG Highest Level Detected Running Annual Average Violations Substance Typical Source Unit of Measure Year Sampled MCL [MRDL] MCLG Lowest Level Detected Highest Level Detected Violations Substance Typical Source Unit of Measure Year Sampled AL MCLG Amount Detected (90th %tile) Sites Above AL/ Total Sites Violations Combined Radium–226 and 228 Erosion of natural deposits pCi/L 2013 5 0 0.41 No Chlorine Water additive used to control microbes ppm 4 4 1.1 0.3 No (Total Trihalomethanes) By-product of drinking water chlorination ppb 2013 80 NA 0.4 5.4 No Barium Discharge of drilling wastes; discharge from metal refineries; erosion of natural deposits ppm 2010 2 2 0.007 0.17 No Copper Corrosion of household plumbing systems; erosion of natural deposits; leaching from wood preservatives ppm 2015 1.3 1.3 0.428 0/35 No Fluoride Erosion of natural deposits; water additive which promotes strong teeth; discharge from fertilizer and aluminum factories ppm 2014 4 4 0.3 1.6 No Chromium Discharge from steel and pulp mills; erosion of natural deposits ppb 2010 100 100 1.21 1.39 No Lead Corrosion of household plumbing systems; erosion of natural deposits ppb 2015 15 0 5 0/35 No COPPER AND LEAD Tap water samples were collected for lead and copper analyses from sample sites throughout the community ---PAGE BREAK--- Water Conservation Program The Moscow Water Department has supplied safe drinking water to the residents and businesses of Moscow Idaho since the 1890s. Through an elaborate system of wells, filters, reservoirs, and miles of underground infrastructure, those individuals who manage it all play a vital role in delivering the precious groundwater to the tap. Conserving this resource has been, and will continue to be, an important goal for the City. The City of Moscow has had a long standing conservation program, dating back to the 1970s. We have supplied effluent reuse water for University of Idaho landscapes. Since that time the program has evolved to include reductions in water use from both commercial and residential customers through the City’s regional management approach, tiered rate structure, and water conservation programs. As one of the pumping entities for the Palouse Ground Water Basin, Moscow agreed to the voluntary goals set by the Palouse Basin Aquifer Committee (PBAC) in 1992. As an active participant of the Palouse Basin Water Summit, Inc., that hosts an annual conference in October, the City continues to work with other communities that share our water source. 2004 brought about more additions to the City’s conservation efforts, which included the Water Waste Resolution, Irrigation Ordinance, and Water Conservation Study that suggested a tiered rate billing structure, adopted in 2007. With the adoption of the Water Conservation Plan in 2016, which includes additional incentives, a more ambitious program is offered. The Water Conservation Program addresses customer water needs at home, at work, and at school. Water saving devices, the outdoor Wisescape® Awards, booth events, education outreach, Wisescape demonstration gardens, and rebates are some of the available resources. Please contact the Water Department for more information about water conservation. Things the Water Department is Doing The Water Department has been busy upgrading water services and maintaining nearly 6,000 water meters and approximately 95 miles of drinking water mains. The department has an on-going fire hydrant replacement program, which targets fire hydrants in need of repairs or upgrades. Fifteen hydrants out of the approximately 863 fire hydrants within the water system are scheduled for replacement this year. We have also set a goal to replace 50 older water services, which can pose problems during emergencies. We are continuing to exercise the City’s 2,683 water main isolation valves to insure the valves work when leaks, line breaks or unplanned emergencies arise. In addition, new isolation valves will be installed in the water distribution system this year; adding these additional valves will help minimize the number of customers without water during emergency shut-downs. The drilling of the City’s new Well No. 10 was completed in 2016 by Boart Longyear of Salt Lake City. The well was completed in the Grande Ronde Aquifer System. The City developed this additional groundwater source to ensure that the system is able to continue to meet needs through the 20-year planning horizon, as well as the reliability and redundancy requirements contained within the state rules. Well No. 10 was successfully drilled and we are pleased with the initial productivity results. Well No. 10 will initially operate as a redundant supply to No. 9, utilizing the same water rights. In 2009, the City was successful in modifying the existing water right for No. 9 to include a second point of diversion, which will be No. 10. CALL US FIRST If you are unsure if a particular issue is your responsibility, call the City first. We will gladly help determine the source of the problem. Some of the services provided by the City of Moscow Public Works Department are: WATER – For water related questions and concerns such as no water, low pressure, water leaks, taste and odor concerns, please call [PHONE REDACTED]. SEWER – For concerns pertaining to sewer overflows, backups or odors, please call [PHONE REDACTED]. STREETS – For blocked storm drains, debris, pot holes, street lights or traffic signal outages, please call [PHONE REDACTED].