Full Text
DOUGLAS COUNTY Planning, Zoning & Land Information Offices 1313 Belknap Street, Room 206 Superior, WI 54880 Zone District I-1 Ordinance & Setbacks Rev. 10-2015 Phone: [PHONE REDACTED] FAX: [PHONE REDACTED] Web: www.douglascountywi.org 3.8I-1INDUSTRIALDISTRICT This district is intended to provide for manufacturing and industrial operations which, on the basis of actual physical and operational characteristics, would not be detrimental to surrounding areas by reason of smoke, noise, dust, odor, traffic, physical appearance or similar factors relating to public health, welfare and safety. Those industries requiring outdoor storage for raw materials and/or finished products may be required to provide a fence or screen in accordance with the provisions of Section 6.0. 1. Permitted Uses Manufacturing, assembly, fabricating, and processing plants and similar type industrial operations consistent with the purposes of this district. General warehousing. Accessory uses clearly incidental to a permitted use. Railroad yards. Essential services and utilities intended to serve the principal permitted use. 2. Uses Authorized by Conditional Permit Salvage yards, subject to the provisions of Section 6.0. Quarrying, mining and processing of products from these activities, subject to the provisions of Section 6.0. Any use determined to be objectionable by the County Zoning Committee on the basis of pollution, noise, dust, smoke, vibration, odor, flashing lights, or danger of explosion may be permitted only upon the issuance of a conditional use permit setting forth dimensional and site requirements, performance standards, aesthetic controls and pollution standards for that particular use. ---PAGE BREAK--- 1 Unless specified elsewhere in this ordinance or on the Official Zoning Map, the dimensional requirements of this schedule shall apply to the respective listed districts. Requirements for the W-1; Resource Conservation, SP-1; Shoreland Protection, and PUD (Planned Unit Development) are contained on the Official Zoning Map. 2 No lot shall be created with a length to width ratio greater than three to one I -1 Zone District Setbacks & Dimensional Requirements1 Maximum Building Height 60’ Minimum Lot Area With Public Sewer 1 acre Without Public Sewer 1 acre Minimum Lot Width2 With Public Sewer 200’ Without Public Sewer 200’ Minimum Lotline Setbacks Front (road setbacks may also apply; see below) 50’ Rear Principal Building 50’ Accessory Building 50’ Side Principal Building 20’ Accessory Building 10’ Class A (State and U.S. Numbered Highways): 130 feet from the centerline of the State or U.S. Highway or 66 feet from the right-of-way line, whichever is greater. Class B (County Highways): 75 feet from the centerline of such highway or 42 feet from the right-of-way line, whichever is greater. Class C (Town Roads / Highways): 63 feet from the centerline of the highway or 30 feet from the right-of-way line, whichever is greater.