Full Text
COMMON LAND USES IN THE ZONE P= Permitted by Right C=Conditional Use Permit Required N=Prohibited PRIMARY USES Automotive–Car Sales & Rental C Subject to 18.38.200 Automotive–Parts Sales C Automotive–Repair & Modification C Community & Religious Assembly C Educational Institutions– Business C Industry–Limited P Industry–General C Offices– Development P Offices–General C Permitted if accessory to an industrial or other primary permitted use Outdoor Storage Yards C Subject to 18.38.200 Recreation– Commercial Indoor C Research & Development P Restaurants– General C Fast food & take- out permitted when part of an industrial complex of 5 or more units. Warehousing & Storage–Enclosed P Wholesaling P 200 S. Anaheim Blvd., Suite 162 Anaheim, California 92805 (714)765-5139 Phone (714)765-5280 Fax www.anaheim.net/planning FEB 2018 Z402 P= Permitted by Right C=Conditional Use Permit Required N=Prohibited ACCESSORY USES Mechanical & Utility Equipment– Ground Mounted P Subject to 18.38.160 Mechanical & Utility Equipment– Roof Mounted P Subject to 18.38.170 Warehousing & Storage–Outdoors P Subject to 18.38.200 Planning Services Division Zone (Industrial) Land Use & Development Standards ---PAGE BREAK--- SETBACKS Thes e setbacks apply in addition to the setback and yard requirements of Chapter 18.10.060 (Building Setbacks). PART I - STREET SETBACK Along any arterial highway: a setback of not less than fifteen (15) feet that shall be fully landscaped. Along collector streets: a setback of not less than fifteen (15) feet that shall be fully landscaped. PART II - INTERIOR SETBACK Along an interior non-residential property lines: 0 feet PARKING AND LOADING Parking and loading requirements for industrial zones are set forth in Chapter 18.42. Click here to reference the Parking Quick Guide SIGNS Sign requirements for industrial zones are set forth in Chapter 18.44. Click here for the Quick Reference Monument Sign handout and click here for the Quick Reference Wall Sign handout. LANDSCAPING Landscaping shall be permitted and/or required in industrial zones, subject to Chapter 18.46 FENCES, WALLS AND HEDGES Fences, walls, hedges and berms shall be permitted and/or required in industrial zones, subject to Section 18.46.110. REFUSE STORAGE AND RECYCLING FACILITIES Refuse storage shall be provided on that property that conforms to the document “Minimum Acceptable Trash Collection Areas" (click here). on file with the Public Works Department. The storage shall be designed, located and/or screened so as not to be readily identifiable or visible from adjacent streets, adjacent residential uses and zones, or other public rights-of-way. MAXIMUM STRUCTURAL HEIGHT The maximum height of any building or structure shall be one hundred (100) feet, except as may be permitted by conditional use permit or as provided below: • Within 200 feet of any residential zone boundary the height shall not exceed one-half (1/2) of the distance from the building or structure to the zone boundaries. • The height of any building or structure within 40 feet of any RS zone boundary may equal, but not exceed 20 feet MAXIMUM FLOOR AREA RATIO .50 FAR (Floor Area Ratio). Calculated by dividing the total floor area of all building floors by the total site area. 200 S. Anaheim Blvd., Suite 162 Anaheim, California 92805 (714)765-5139 Phone (714)765-5280 Fax www.anaheim.net/planning FEB 2018 Z402 Along local streets: a setback of not less than five feet that shall be fully landscaped. Along a freeway, frontage road, freeway on/off ramps: a setback of not less than thirty (30) feet that shall be fully landscaped.